Note:
Install the washers with the cup side facing
the handle.
Note:
You can adjust the handle height for
comfortable operation. Stand behind the handle to
determine the height. To adjust the handle height,
position the bolts and the locknuts that secure the
handle latches to the handle into the other mounting
holes in the latches.
3. Insert the carriage bolt through the bag aligning
plate and the second hole from the top on the left
side of the handle, and secure it with a cap locknut
(Figure 3).
4. Slide the bag support rod through the third from the
top mounting holes in the handle, and secure each
end with a cap locknut (Figure 3).
5. Use cable ties to secure the control cables to the
handle (Figure 3).
2
Installing the Discharge Tunnel
Plug
Parts needed for this procedure:
1
Discharge tunnel plug
Procedure
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Figure 4). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
Figure 4
1.
Discharge door handle
2.
Plug, rotated clockwise
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Figure 4).
Note:
Ensure that the arrow on the plug decal
points upward.
3. Push the plug all the way in until the spring clip on
the bottom of the plug clicks into place, locking the
plug securely into the discharge tunnel (Figure 5).
Figure 5
1.
Spring clip
4. Release the discharge door handle to lock the top
of the plug.
3
Filling the Crankcase with Oil
No Parts Required
Procedure
The engine crankcase is shipped without oil.
You
must fill it with approximately 22 ounces (0.65 l) of oil
before starting the engine. Refer to Checking the Engine
Oil Level in Operation , page 9 for oil specifications and
instructions.
8
Summary of Contents for Recycler 22191
Page 30: ...Notes 30 ...
Page 31: ...Notes 31 ...
