Setup
Important:
Remove and discard the protective plastic
sheet that covers the engine.
1
Attaching the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1.
Remove the handle knobs from the machine housing
(Figure 3).
Important:
Route the cables to the outside of the
handle as you install the handle.
1
G020270
Figure 3
1.
Handle knob (2)
2.
Move the handle to the operating position.
3.
Install and tighten the handle knobs that you removed
in step 1 (Figure 3).
4.
Move the upper handle to the desired position and
tighten the upper handle knob firmly (Figure 4).
G020354
Figure 4
2
Assembling the Grass Bag
No Parts Required
Procedure
1.
Slide the bag over the wire frame as shown in Figure 5.
Figure 5
2.
Snap the clips onto the wire frame as shown in Figure 6.
5
