
•
A green light indicates that the charger is fully
charged or the charger is disconnected from the
battery.
•
A flashing light that alternates between red and
green indicates that the battery is nearly fully
charged. This state lasts only a few minutes until
the battery is fully charged.
Replacing the Fuse
Electric-Start Model Only
If the battery does not charge or the engine does not
run with the electric starter, the fuse may be blown.
Replace it with a 40 A plug-in type fuse.
1.
Refer to
Preparing for Maintenance (page 20)
.
2.
Raise the rear deflector and locate the battery
compartment (
Note:
There is an adhesive-backed covering
that protects the battery compartment.
g009506
Figure 31
1.
Rear deflector
3.
Battery
2.
Screw
4.
Battery compartment
3.
Wipe away any debris in the battery compartment
area and remove the adhesive-backed covering.
4.
Remove the screw that secures the battery
compartment, pull out the battery, and locate the
fuse (
and
g030022
Figure 32
1.
Battery cover
3.
Fuse holder
2.
Fuse
5.
Replace the fuse in the fuse holder (
).
Note:
Your machine comes with a spare fuse
attached to the battery-charger box (Figure 37).
g030053
Figure 33
1.
Battery compartment
2.
Battery-charger box
6.
Install the battery compartment with the screw
that you removed in step
.
7.
Install the covering over the battery
compartment.
8.
Lower the rear deflector.
23