Toro Recycler 20357, Operator'S Manual

Page: 8 / 72

g206254
Figure 7
1. Full 3. Low
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait about 3 minutes for the oil to settle in the
engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
7. Read the oil level on the dipstick ( Figure 7 ).
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
3 through 5 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Changing the
Engine Oil (page 18) .
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
4
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
Figure 8 .
g027257
Figure 8
1. Handle
3. Grass bag
2. Frame
Note:
Do not slip the bag over the handle
( Figure 8 ).
2. Hook the bottom channel of the bag onto the
bottom of the frame (
Figure 9 ).
7