Toro Recycler 20339, Operator'S Manual

Page: 8 / 68

3. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
6. Read the oil level on the dipstick ( Figure 6 ).
•
If the oil level is below the Add mark on the
dipstick, carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat steps
3
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick; refer to
Changing
the Engine Oil (page 16) .
Important:
If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
7. Install the dipstick securely.
4
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in Figure 7 .
1
2
3
g027120
g027120
Figure 7
1. Handle 3. Grass bag
2. Frame
Note:
Do not slip the bag over the handle ( Figure 7 ).
2. Hook the bottom channel of the bag onto the bottom
of the frame (
Figure 8 ).
g027121
g027121
Figure 8
3. Hook the top and side channels of the bag onto the top
and sides of the frame, respectively (
Figure 8 ).
6