9
Starting And Stopping
Before Starting The Engine
1.
Fill the fuel tank as instructed in the Before
Operation section of this manual.
2.
Rest the Edger on the ground.
3.
Make sure the Edger blade is clear of any broken
glass, nails, wire, rocks or other debris.
4.
Keep all bystanders, children and animals away
from the working area.
Cold Starting Procedure
The carburetors on Toro engines contain a choke
system. To start a “cold” engine properly, perform the
following procedure:
1.
Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank (Fig. 13).
(Flowing fuel should be almost clear, not foamy
or full of bubbles.)
2.
Move the choke lever to the closed (
) position
and move the stop switch to the “ON” position
(Figs. 14 and 15).
3.
Lock the throttle trigger in the fast-idle start
position, then pull the starter handle (Figs. 14
and 15).
4.
After the engine starts, move the choke lever to
the open (
) position, then squeeze and release
the throttle trigger to allow it to return to the idle
position (Figs. 14 and 15).
If the engine stops running before you move the
choke lever to the open (
) position:
A.
Go ahead and open the choke (Fig. 14).
B.
Make sure the throttle trigger is set to the
fast-idle start position (Fig. 15).
C.
Pull the starter handle until the engine starts
(Fig. 14).
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68
_
F
(20
_
C):
1.
Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank (Fig. 13).
2.
Move the choke lever to the open (
) position
and move the stop switch to the “ON” position
(Figs. 14 and 15).
3.
Leave the throttle trigger in the idle position and
pull the starter handle (Figs. 14 and 15).
4.
If the engine fails to start after three to four
pulls, follow the instructions in the Cold Starting
Procedure section above.
If the engine fails to start after you follow the
above procedures, contact an authorized Toro
dealer.
To Stop The Engine:
1.
Release the throttle trigger (Fig. 15).
2.
Slide the stop switch to the “STOP”
position
(Fig. 15).
Idle Speed Adjustment
This Edger is equipped with non-adjustable fuel
mixture carburetor. The engine idle speed is the only
adjustment for the operator.
Summary of Contents for ProLine 53030
Page 14: ......
