Toro ProLine 30188, Operator'S Manual

Page: 13 / 44

Assembly
11
Install Muffler Guard
1. Remove screws securing muffler to engine and
exhaust pipe to muffler (Fig. 3).
2. Slide muffler guard over muffler and secure with
previously removed engine screws (Fig. 3).
3. Install pipe guard onto muffler guard with
previously removed muffler screw, 10–24 x 5/8”
(16mm) screw and 10–24 nut
m–3105
1
6
4
3
5
2
Figure 2
1. Muffler guard
2. Pipe guard
3. Engine screw
4. Muffler screw
5. Screw 10–24 x 5/8”
(16mm)
6. Nut 10–24
Install Upper Handle
1. Align upper handle with mounting holes in rear
frame (Fig. 3). Select high, medium or low
position for lower mounting hole.
2. Secure each side with (2) 3/8–16 x 1” (26mm)
flange bolts and flange nuts (Fig. 3). Torque
bolts to 25 ft. lbs. (34 N.m).
m–3063
1
2
3
4
Figure 3
1. Upper handle
2. Rear frame
3. Flange bolt 3/8–16 x 1”
(26mm)
4. Flange nut 3/8”
Install Control Rods
Before installing and adjusting control rods loosen
quick release levers and move reference control bar
all the way forward.
Left Control Rod
1. Slide clevis pin through rod fitting and mounting
hole in control bracket (from outside). Secure
with washer and hairpin cotter (Fig. 4).
2. Remove hairpin cotter and rod from upper
control bars.
3. Press and hold upper control bars against
reference bar, so stop hits.