Toro ProCore, Service Manual

Page: 100 / 122

ProCore Processor Page 6 -- 24 Chassis
Brush Assembly
1. Grease fitting
2. Front angle
3. Front rubber shield
4. Skirt plate
5. Rotating corner shaft
6. Scraper plate
7. Angle plate (2 used)
8. Side shield (2 used)
9. Side skirt plate (2 used)
10. Flange bearing (2 used)
11. Brush assembly
12. Carriage screw (2 used per bearing)
13. Carriage screw (7 used)
14. Flange nut (29 used)
15. Carriage screw (14 used)
16. Carriage screw (4 used)
17. Bearing (2 used)
18. Lock nut (4 used per bearing)
19. Carriage screw (4 used per bearing)
20. Flat washer (4 used per bearing)
21. Grease fitting
22. Rubber scraper cover
23. Carriage screw (7 used)
24. Flange nut (7 used)
25. Drive belt
26. Set screw
27. Square key
28. Pulley (chopper axle)
29. Set screw
30. Cap screw (3 used)
31. Lock washer (3 used)
32. Taper lock bushing
33. Square key
34. Pulley
35. Pulley (rotating corner shaft)
36. Square key
37. Set screw (2 used per pulley)
38. Drive belt
39. Square key
40. Pulley (brush shaft)
Figure 26
FRONT
RIGHT
3
2
12 5
6
13
18
17
16
19
15
20
24
22
23
14
4
8
7
9
10
11
4
14
14
14 15
1
21
333 to 387 in--lb
(38 to 43 N--m)
30
28
26
27
25
29
31
32
33
34
Antiseize
Lubricant
35
36
37
38
39
40
Loctite #242
Drive for the brush shaft is delivered on the right side of
the machine from the chopper axle by a toothed belt.
The left end of the brush shaft drives the rotating corner
shaft with an A--section drive belt. Adjustable idler pul-
leys maintain belt tension.
Removal (Fig. 26)
1. Have ProCore Processor attached to tow vehicle
and park machines on a level surface with the Processor
fully lowered. Engage vehicle parking brake, stop en-
gine and remove key from the ignition switch. Make sure
that ProCore Processor engine is off. Chock wheels to
prevent movement of either machine.