Toro Pro Sweep 07068, Operator'S Manual

Page: 19 / 40

Diagnostic Light
The diagnostic light ( Figure 19 ) is located on the front
cover and indicates machine fault codes. After you
turn the key to the R
UN
position, the diagnostic light
illuminates for 5 seconds, turns off for 5 seconds, and
then begins flashing 3 times a second until you push a
button on the handheld remote. If the light turns on for
5 seconds and then starts blinking 10 times a second
(with or without a 5 second pause), there is a fault with
the machine; refer to
Checking Fault Codes (page 34) .
Note:
The diagnostic light illuminates when a button
is pushed on the handheld remote.
Note:
If you have a button pressed on the handheld
remote when you start the machine, the light does not
flash 3 times a second after it turns off for 5 seconds.
g030471
Figure 19
1. Diagnostic light
Specifications
Note:
Specifications and design are subject to
change without notice.
Dimensions and Weights
Width 221 cm (87 inches)
Height 202 cm (79-1/2 inches)
Dump height clearance 173 cm (68 inches)
Length Hopper lowered—173
cm (68 inches)
Hopper raised—229 to
249 cm (90 to 98 inches)
Empty weight 680 kg (1,500 lb)
Gross vehicle weight (GVW) 1588 kg (3,500 lb)
Radio Specifications
Frequency 2.4 GHz
Max output power 19.59 dBm
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
19