Toro Pro Force Debris Blower, Installation Instructions

Page: 1 / 4

Form No. 3404-625 Rev A
10 Gallon Fuel Tank Kit
Pro Force ® Debris Blower
Model No. 130-4371
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
1
Removing the Fuel Tank
No Parts Required
Procedure
1. Park the machine on a level surface, shut off the engine,
chock the wheels, disconnect the battery, and remove
the key from the ignition switch.
2. Allow the engine to cool, then drain the fuel tank.
Note:
Dispose of fuel properly. Recycle according
to local codes.
3. Restart the engine and run it until it stops.
4. Choke the engine. Start and run the engine until it will
not start.
5. Disconnect the fuel tank hoses from the machine and
discard them (
Figure 1 ).
Note:
Retain the hose clamps.
6. Remove the fasteners and straps securing the fuel tank
to the machine and discard them along with the tank
(
Figure 1 ).
7. Disconnect the remaining hoses from the carbon
canister (
Figure 1 ).
Note:
Retain the hose clamps.
8. Remove the battery cover and battery ( Figure 1 ); refer
to your Operator’s Manual .
9. Remove the carbon canister and discard it ( Figure 1 ).
Figure 1
1. Battery cover 3. Fuel-tank hoses
2. Carbon canister 4. Fuel tank
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3404-625* A