Preparing the Machine for
Weld Repairs
Important:
Failure to disconnect the battery
may permanently damage to the wireless-control
module and the TEC controller.
•
Disconnect the negative-battery cable from the
battery before welding on the machine.
•
Connect the negative-battery cable to the battery
after you finish welding on the machine.
Engine Maintenance
Engine Safety
•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Do not change the governor speed or overspeed
the engine.
Servicing the Air Cleaner
Service Interval:
Every 100 hours—Replace the air
filter element (more frequently if
conditions are dusty or sandy).
Checking the Air Filter
1.
Check the air cleaner body for damage, which
could possibly cause an air leak. Ensure that
the cover seals around the air-cleaner body
(
).
Note:
Replace a damaged air-cleaner cover
or housing.
g002097
Figure 20
1.
Latch
3.
Air-filter element
2.
Air-filter cover
2.
Release the latches securing the air-filter cover
to the air-filter housing (
3.
Separate the air-filter cover from the air-filter
housing, and clean the inside of the cover
(
).
4.
Gently slide the air-filter element out of the filter
housing.
Note:
To reduce the amount of dust dislodged,
avoid knocking the filter against the air-filter
housing.
5.
Inspect the air-filter element.
25
Summary of Contents for Pro Force 44553
Page 41: ...Notes ...
Page 44: ......