Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
Handle bolts
2
Curved washers
2
1
Locknuts
2
Install the upper handle.
Hairpin cotter
2
2
Flat washer
3
Install the traction control linkage.
Nut
2
Carriage bolt
2
3
Flat washer
2
Install the chute.
Carriage bolts
2
4
Locknuts
2
Install the chute control rod.
5
No parts required
–
Fill the engine with oil.
6
No parts required
–
Check the tire pressure.
7
No parts required
–
Check the skids.
8
No parts required
–
Check the operation of the traction drive.
1
Installing the Upper Handle
Parts needed for this procedure:
2
Handle bolts
2
Curved washers
2
Locknuts
Procedure
1.
Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
2.
Install 2 handle bolts, 2 curved washers, and 2 locknuts
in the lower handle holes (Figure 3).
Figure 3
8
