Toro Power Plex 88540, Operator'S Manual

Page: 8 / 12

g194423
Figure 4
1. Charger venting areas 3. Right indicator light
2. Left indicator light
5. To remove the battery pack, slide the battery backward
out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light Right Light Indicates:
Off Red
Charger is on; no battery
pack inserted
Red Red Battery pack is charging
Green Red Battery pack is charged
Orange Red Battery pack is too warm
Red Blinking Red Replace the battery pack
Installing the Battery Pack
Important:
Operate the battery only in temperatures
that are -15°C (5°F) to 65°C (149°F).
1. Make sure that the vents on the battery are clear of any
dust and debris.
2. Line up the cavity in the battery pack with the tongue
on the tool.
3. Grasp the trigger handle.
4. Slide the battery pack into the tool until the battery
locks into the latch (
Figure 5 ).
g189881
Figure 5
(Trimmer shown)
1. Battery latch
Removing the Battery Pack
Press the battery latch on the tool to release the battery pack
and slide the battery pack out of the tool (
Figure 6 ).
g192774
Figure 6
(Trimmer shown)
1. Battery latch
8