Left Light
Right Light
Indicates:
Off
Red
Charger is on; no battery
pack inserted
Red
Red
Battery pack is charging
Green
Red
Battery pack is charged
Orange
Red
Battery pack is too warm
Red Blinking
Red
Replace the battery pack
Advancing the Line Using
the Bump Feed
1.
Run the tool at full throttle.
2.
Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector will cut the line to the correct
length.
Note:
If the line is worn too short you may not
be able to advance the line by tapping it on the
ground. If so, release the trigger and refer to
Advancing the Line Manually (page 11)
.
g194633
Figure 11
1.
Bump button
Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
the line.
Adjusting the Auxiliary
Handle
1.
Release the auxiliary-handle latch (A of
Figure
12
).
2.
Slide the auxiliary handle up or down to your
desired height (B of
Figure 12
).
Important:
Do not remove the rubber
bumper.
3.
Close the auxiliary-handle latch to secure the
auxiliary handle in place (C of
Figure 12
).
g189875
Figure 12
Trimming
g189990
Figure 13
11
