Toro Power Max HD 1028 OHXE 38826, Operator'S Manual

Page: 24 / 32

G016646
Figure 50
3. Remove and discard the old spark plug.
Note:
You will need a ratchet wrench extension to
remove the spark plug.
4. Set the gap between the electrodes on a new spark plug
at 0.030 inch (0.76 mm) (
Figure 51 ).
Figure 51
1. 0.030 inch (0.76 mm)
5. Install the new spark plug, tighten it firmly, and attach
the ignition wire to the spark plug.
Note:
Ensure the ignition wire snaps completely into
place on the spark plug.
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover ( Figure 52 ), lift
the front of the cover up, and slide it back and out of
the way.
Figure 52
2. Loosen the bolt on the cable clamp ( Figure 53 ).
Figure 53
1. Cable conduit 2. Cable clamp
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (
Figure 53 and Figure 54 ).
Figure 54
1. Discharge chute latch 2. Gear teeth
Note:
The latch is spring loaded and will naturally
move into the teeth of the gear ( Figure 54 ).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
6. Install and secure the gear cover.
24