Toro Power Max 724 OE, Operator'S Manual

Page: 6 / 28

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Handle bolts 2
Curved washers 2
1
Locknuts 2
Install the upper handle.
Hairpin cotter 2
2
Flat washer 3
Install the traction control linkage.
Nut 2
Carriage bolt
2
3
Flat washer 2
Install the chute.
Carriage bolts 2
4
Locknuts 2
Install the chute control rod.
5
No parts required
–
Check the engine oil level.
6
No parts required
–
Check the tire pressure.
7
No parts required
–
Check the skids.
8
No parts required
–
Check the operation of the traction drive.
1
Installing the Upper Handle
Parts needed for this procedure:
2 Handle bolts
2 Curved washers
2 Locknuts
Procedure
1. Lift and rotate the upper handle and position it over
the lower handle (
Figure 3 ).
2. Install 2 handle bolts, 2 curved washers, and 2 locknuts
in the lower handle holes (
Figure 3 ).
g019003
Figure 3
6