Toro Polar Trac Cab 30474, Operator'S Manual

Page: 26 / 60

9
Installing the Skid Plate
Kubota Engine Only
Parts needed for this procedure:
1 Skid plate
2 Bolt (3/8 x 1-1/4 inches)
2 Bolt (3/8 x 1 inch)
4 Flange nut (3/8 inch)
Procedure
Use the bolt (3/8 x 1-1/4 inches), (3/8 x 1 inch), and
nuts to secure the skid plate to the frame (
Figure 45 ).
g032568
Figure 45
1. Bolt (3/8 x 1-1/4 inches) 3. Bolt (3/8 x 1 inch)
2. Skid plate 4. Flange nut (3/8 inch)
10
Removing the Roll Bar
No Parts Required
Procedure
Note:
Have another person help you remove the roll
bar from the machine.
1. Have another person support the roll bar.
2. Remove the hairpins and the pivot-lock pins
from the roll bar and set the hairpins aside
(
Figure 46 ).
g032775
Figure 46
1. Pivot bolt 4. Pivot-lock pin
2. Lanyard washer 5. Lower-ROPS pin
3. Roll bar 6. Hairpin
3. Remove the pivot bolt and lanyard washer.
4. Remove the roll bar from the machine.
5. Store the roll bar.
Note:
Retain or loosely install the hardware that you
removed during this procedure so that it is available
for seasonal changeover.
26