Testing the Safety-Interlock
System
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1.
While sitting on the seat, with the control levers
in the P
ARK
position, and move the blade-control
switch to the O
N
position. Try starting the
engine; the engine should not crank.
2.
While sitting on the seat, move the blade-control
switch to the O
FF
position. Move either motion
control lever to the center, unlocked position. Try
starting the engine; the engine should not crank.
Repeat with the other motion-control lever.
3.
While sitting on the seat, move the blade
control switch to the O
FF
position, and lock the
motion-control levers in the P
ARK
position. Start
the engine. While the engine is running, engage
the blade-control switch, and rise slightly from
the seat; the engine should stop.
4.
While sitting on the seat, move the blade-control
switch to the O
FF
position, and lock the
motion-control levers in the P
ARK
position. Start
the engine. While the engine is running, move
the motion-control levers to the center, unlocked
position, engage the blade-control switch, and
rise slightly from the seat; the engine should
stop.
Starting the Engine
Important:
Do not engage the starter for more
than 10 seconds at a time. If the engine fails to
start, wait 60 seconds between attempts. Failure
to follow these instructions can damage the
starter motor.
g027578
Figure 11
Operating the Blades
The blade-control switch engages and disengages
power to the mower blades. This switch controls
power to any attachments that draw power from the
engine, including the mower deck and cutting blades.
Engaging the Blades
Important:
Do not engage the blades when the
machine is parked in tall grass. Belt or clutch
damage can occur.
17
