g002246
Figure 78
1.
Inner drain plug
5.
Move the vehicle slowly until the wheel is
positioned for filling (
).
g002245
Figure 79
1.
Upper hole—add fluid
here
2.
Lower hole
6.
Set the parking brake, stop the pump, stop the
engine, and remove the key from the starter
switch.
7.
Pour SAE 85W-140 weight gear lube into the
upper hole until it begins to come out of the
lower hole.
8.
Replace and tighten all drain plugs.
9.
Repeat steps
through
for the other rear
wheel.
10.
Dispose of the used oil at a certified recycling
center.
Adjusting the Front Wheel
Toe-in
Service Interval:
Every 200 hours/Yearly (whichever
comes first)
The toe-in should be 0 to 3 mm (0 to 1/8 inch).
1.
Check and fill all tires; refer to
.
2.
Measure the distance between both of the front
tires at the axle height at both the front and rear
of the front tires (
).
Note:
The distance between the front of the
tires should be 0 to 3 mm (0 to 1/8 inch) less
than the distance between the back side of the
front tires.
g002247
Figure 80
1.
Tire center line—back
3.
Axle center line
2.
Tire center line—front
3.
If the measurement does not fall within the
specified range, loosen the jam nuts at both
ends of the tie rod (
g002248
Figure 81
1.
Jam nut
2.
Tie rod
4.
Rotate the tie rod to move the front of the tire
inward or outward.
64
Summary of Contents for Multi Pro ExcelaRate 5800-G
Page 73: ...Spray System Schematic g034336 Figure 92 73...
Page 86: ...Notes...
Page 87: ...Notes...
