materials have been chosen for specific reasons at
different locations on your sprayer to meet this goal.
Unfortunately, there is no single material which is
perfect for all foreseeable applications.
Some chemicals are more aggressive than others
and each chemical interacts differently with various
materials. Some consistencies (e.g., wettable
powders, charcoal) are more abrasive and lead to
higher wear rates. If a chemical is available in a
formulation that would provide increased life to the
sprayer, use this alternative formulation.
As always, remember to clean your sprayer and spray
system thoroughly after all applications. This ensures
that your sprayer has a long and trouble-free life.
Note:
If you have questions or need additional
information regarding the spray-control system, refer
to the
Operator’s Manual
supplied with the system.
Sprayer Functions for
Application Rate Mode and
Manual Mode
Refer to the
Software Guide
for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system for information on the following:
Before Operation
•
The InfoCenter home screen
•
The main menu screen
•
The main menu sub-screens
•
The service screens
•
The diagnostic screens
•
The About screens
During Operation
•
Entering job information
•
InfoCenter spray-area screens
•
InfoCenter advisories
Spraying with the
ExcelaRate Sprayer System
Refer to the
Software Guide
for the Multi Pro 5800-D
and 5800-G turf sprayers with ExcelaRate spray
system for information on the following procedures:
Important:
To ensure that the product remains
well mixed, use the agitation feature whenever
you have solution in the tank.
Spraying in the Application Rate
Mode
1.
Ensure that the spray system is calibrated
for the active spray nozzles that you have
selected; Refer to the
Software Guide
for the
Multi Pro 5800-D and 5800-G turf sprayers with
ExcelaRate spray system.
2.
Rotate the knob for the section-bypass shutoff
valve to the closed position (
).
g192607
Figure 39
1.
Section-bypass shutoff valve (closed position)
3.
Set the sprayer mode button to the Application
Rate Mode (
g193437
Figure 40
1.
Application-rate mode
position
2.
Sprayer-mode switch
4.
Move the sprayer to the area of turf that you
are spraying.
5.
If you are collecting area sprayed and volume
sprayed data for each job site, select a sub-area
screen (sub-areas 1 through 20) to record for
the individual area and volume information; refer
to Using the Sub-Area Screen in the
Software
35
