Toro Multi Pro 315000001, Operator'S Manual

Page: 2 / 12

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the machine.
Hose hook 1
Flanged locknut (3/8 inch) 4
Flanged locknut (5/16 inch) 4
Carriage bolt (3/8 x 3/4 inch)
4
Carriage bolt (5/16 x 1 inch) 4
R-clamp 2
2
Spray-gun bracket 1
Install the hose hook and spray-gun
bracket.
Female cap 1
3
Shutoff valve 1
Install the shutoff valve (Multi Pro 1750
and Multi Pro WM only).
Spray-gun valve
1
Hose-reel supply hose 1
Flange clamp 1
Gasket 1
Fitting, 90-degree 1
4
Hose clamp 1
Install the control valve.
Spray gun assembly 1
Straight barbed fitting 1
5
Hose clamp 1
Connect the spray hose.
1
Preparing the Machine
No Parts Required
Procedure
1. Ensure that the machine is empty of all fluids. If
chemicals have been used in the machine, flush the
system thoroughly with clean water and drain the water;
refer to your vehicle
Operator’s Manual for instructions.
2. Disconnect the negative battery terminal from the
battery.
2
Installing the Hose Hook and
Spray-Gun Bracket
Parts needed for this procedure:
1 Hose hook
4 Flanged locknut (3/8 inch)
4 Flanged locknut (5/16 inch)
4 Carriage bolt (3/8 x 3/4 inch)
4 Carriage bolt (5/16 x 1 inch)
2 R-clamp
1 Spray-gun bracket
Procedure
1. Loosen the tank strap.
•
For the Multi Pro 1750 and Multi Pro 5800, loosen
the front, right strap (
Figure 1 ).
2