Toro Multi Pro 1750, Operator'S Manual

Page: 41 / 76

g216324
g216325
Figure 32
1. Grease fitting (outboard
side of the spray pump) 3. Front of the machine
2. Grease fitting (bottom,
rear side of the spray
pump)
4. Pump grease into each remote grease fitting
(
Figure 32 A and Figure 32 B).
5. Wipe off the excess grease.
Greasing the Section
Hinges
Service Interval: Every 100 hours
Important:
If the section hinge is washed with
water, clear all water and debris from the hinge
assembly and apply fresh grease.
Grease Type: No. 2 lithium grease
1. Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Pump grease into the bearing or bushing at
each fitting (
Figure 33 ).
g002014
Figure 33
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each section pivot.
41