Toro LSSS Installation And User Manual Download Page 11

10

© 2020 The Toro Company • Irrigation Division • www.toro.com

Part Number 373-0918 Rev. F

The sensor input board is covered by this warranty for a period 

of  one year from the date of  installation.

Neither Toro nor Toro Warranty Company is liable for indirect, 

incidental or consequential damages in connection with the 

use of  equipment, including but not limited to: vegetation loss, 

the cost of substitute equipment or services required during 

periods of  malfunction or resulting non-use, property damage 

or personal injury resulting from installer’s actions, whether 

negligent or otherwise. Some states do not allow the exclusion 

of  incidental or consequential damages, so the above exclusion 

may not apply to you.

All implied warranties, including those if merchantability and 

fitness for use, are limited to the duration of  this express 

warranty. Some states do not allow limitations on how long an 

implied warranty lasts, so the above limitation may not apply to 

you. This warranty gives you specific legal rights and you may 

have other rights which vary from state to state.

This device complies with FCC rules Part 15. Operation is 

subject to the following two conditions: (1) This device may 

not cause harmful interference and (2) this device must accept 

any interference that may be received, including interference 

that may cause undesirable operation. This equipment generates 

and uses radio frequency energy and if  not installed and used 

properly, that is, in strict accordance with the manufacturer’s 

instruction, may cause interference to radio and television 

reception. It has been type tested and found to comply with 

the limits for a FCC Class B computing device in accordance 

with the specification in subpart J of  Part 15 of  FCC Rules, 

which are designed to provide reasonable protection against 

such interference in a residential installation. However, there is 

no guarantee that the interference will not occur in a particular 

installation. 

If  this equipment does cause interference to radio or television 

reception, which can be determined by turning the equipment 

off  and on, the user is encouraged to try to correct the 

interference by one or more of  the following measures:

(1) Reorient or relocate the receiving antenna.

(2) Increase the separation between the equipment and receiver.

(3) Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected.

(4) Consult the dealer or an experienced radio or television 

technician for assistance. The user may find the following booklet 

prepared by the Federal Communications Commission helpful: 

“How to identify and Resolve Radio-TV Interference Problems”. 

This booklet is available from the U.S. Government Printing 

Office, Washington, DC 20402. Stock No. 004-00345-4m.

The Toro Promise - Limited One-Year Warranty

Electromagnetic Compatibility

Summary of Contents for LSSS












Reviews: