17
m–3313
1
Figure 18
1. Cruise control
Engaging the Cruise Control
1.
Drive the tractor forward and obtain the desired speed.
2.
While holding your foot steady on the traction control
pedal, push the cruise control switch (Fig. 18) to the
set position.
This locks the traction control in position.
3.
Remove your foot from the traction control.
Note:
If you initially set the cruise control to any speed
other than full speed, you can speed up with your foot on
the traction pedal for as needed. When you release the
traction pedal, the cruise speed you set previously resumes
automatically.
Important
If you accidentally press the cruise control
while the engine is running and you are not moving, the
machine will subsequently operate at partial speed in
forward and will not operate in reverse. To correct this
situation, move the cruise control switch to the off
position or press the brake pedal to disengage the cruise
control.
Disengaging the Cruise Control
To disengage the cruise control, complete one of the
following steps:
•
While holding your foot steady on the traction control,
move the cruise control switch to the off position
(Fig. 18).
•
Press the brake pedal.
This automatically disengages the cruise control and
applies the brake at the same time.
Raising and Lowering
Attachments
Raise and lower attachments using the attachment power
lift lever. This lever is located to the right of the steering
wheel (Fig. 19).
m–3258
1
Figure 19
1. Attachment power lift lever
Raising Attachments
1.
Start the tractor.
2.
Pull the lift lever up to raise the attachment (Fig. 20).
m–3315
1
2
Figure 20
1. Lift lever, Up
2. Lift lever, Down
3.
Release the lever when the attachment has reached the
desired height.
The attachment will remain in the raised position until
you lower it again.
When the engine is off, attachments in the raised
position may gradually lower, possibly pinning or
injuring you or a bystander.
Lower the attachment lift before stopping the
engine.
Warning