Toro Groundsmaster 7210, Service Manual

Page: 298 / 342

Removing the Operator Seat (continued)
2. Unlatch the operator seat and raise it.
WARNING
To prevent injury, do not attempt to reach the seat switch through
the openings in the seat plate.
If seat switch service is necessary, remove the seat from the seat
plate to access the switch.
g033704
Figure 212
1. Harness connector 3. Flange nut
2. Latch angle
3. Disconnect the machine wire harness electrical connector from the seat
switch harness connector ( Figure 212 ).
4. Support the seat and latch angles to prevent them from shifting during seat
removal.
5. Remove the 4 flange nuts that attach the seat and latch angles to the seat
plate, and remove the seat from the machine.
6. Remove the seat parts as shown in Figure 211 .
Installing the Operator Seat
1. Install all the removed seat parts ( Figure 211 ).
2. Align the seat and latch angles to the seat plate. Secure the assembly with
the 4 flange nuts.
3. Connect the wire harness electrical connector to the seat switch harness
( Figure 212 ).
4. Lower the seat and latch it.
5. Check the operation of the operator seat switch.
Chassis: Service and Repairs Page 6–36 Groundsmaster 7210
16222SL Rev C