Adjusting the Rollers and
Gage Wheel
Note:
If you want to use the cutting unit in the 25 mm
(1 inch) or 38 mm (1-1/2 inches) height-of-cut setting,
position the cutting unit rollers in the top bracket holes.
Adjusting the Front Roller
1.
Remove the capscrew and nut securing the
roller shaft to the cutting unit bracket (
).
g010788
Figure 11
1.
External roller
2.
Roller shaft
2.
Slide the shaft out of the lower bracket holes,
align the roller with the top holes, and install the
shaft.
3.
Secure the roller shaft to the cutting unit bracket
with the capscrew and nut.
Adjusting the Front Gage Wheel
1.
Remove the capscrew and nut securing the
gage wheel to the cutting unit brackets (
g010789
Figure 12
1.
Gage wheel
2.
Align the roller and spacer with the top holes in
the brackets and secure them with the capscrew
and nut.
Adjusting the Rear (Internal)
Rollers
1.
Remove the cotter pins securing the roller shafts
to the brackets on the underside of the deck
(
).
g010790
Figure 13
1.
Internal rollers
2.
Slide the shafts out of the lower bracket holes,
align the rollers with the top holes, and install
the shafts.
3.
Install the cotter pins to secure the assemblies.
Adjusting the Weight
Transfer
On Groundsmaster 3280-D and 3320 models only,
refer to the traction unit
Operator's Manual
for the
procedure to adjust the counterbalance pressure for
best performance.
14
