Toro Groundsmaster 139-1030, Installation Instructions Manual

Page: 2 / 12

1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Lower the cutting units.
4. Shut off the engine and remove the key.
2
Disconnecting the Battery
No Parts Required
Procedure
1. Open the hood ( Figure 1 ).
g251777
Figure 1
2. Rotate the battery disconnect switch to the O
FF
position, refer to the Operator’s Manual for your
machine.
3
Removing the Side Panels
No Parts Required
Procedure
1. Loosen the 2 knobs that secure the left and right
side panels to the machine (
Figure 2 ).
g251780
Figure 2
Right side panel shown
1. Side panel 2. Knobs
2. Remove the side panels from the machine
(
Figure 2 ).
4
Removing the 28-V
Solenoid
No Parts Required
Procedure
Note:
Your machine may have up to 3 fuses on the
fuse bracket towards the rear end of the machine. For
this procedure, remove the 28-V solenoid under the
fuse holder shown in
Figure 3 .
2