9
Installing the Cutting Deck
1. Position the cutting deck under the carrier frame.
2. Mount the cutting deck to the carrier frame with 4
clevis pins and hairpin cotters (Fig. 8).
Note: All four pins must be in the same hole locations to
prevent uneven cutting.
8
11
1
3
5
7
2
4
6
m–4140
9
10
Figure 8
1.
1in. (25 mm) Cut Height
2.
1-1/2in. (38 mm) Cut
Height
3.
2in. (51 mm) Cut Height
4.
2-1/2in. (64 mm) Cut
Height
5.
3in. (76 mm) Cut Height
6.
3-1/2in. (89 mm) Cut
Height
7.
4in. (102 mm) Cut Height
8.
Clevis Pin
9.
Carrier Frame
10. Cutting Deck
11. Hairpin Cotter
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Operating the Power Take Off
(PTO)
The power take off (PTO) switch engages and disengages
power to the electric clutch.
Engaging the PTO
1. Release the parking brake.
2. Release pressure on the traction pedal to stop
movement.
3. To engage lift cover and move the PTO switch to the
on position (Fig. 9).
Disengaging the PTO
1. Closing the cover moves the PTO switch to the off
position (Fig. 9).
m–3154
1
Figure 9
1.
PTO switch
Implement Lift Lever
The implement lift lever (Fig. 10) is used to raise and
lower various attachments.
Raising Attachments
1. Remove pressure from traction pedal to stop the
machine.
2. Pull implement lift lever (Fig. 10) rearward to raise
attachment to the desired height.
Lowering Attachments
1. Remove pressure from traction pedal to stop the
machine.
2. Push implement lift lever (Fig. 10) forward to lower
attachment.
Note: Hold lift lever in down position 1–2 seconds after
attachment in down to extend lift cylinder allowing
attachment to float with changes in ground contour.
