Servicing the Blade Spindle (Standard Series Cutting Units)
g315887
Figure 134
1.
Lock nut
6.
Bearing spacer
2.
Disc spring washer
7.
Spindle housing
3.
Pulley
8.
Bottom guard
4.
Bearing guard
9.
Spindle shaft
5.
Ball bearing (2 each)
10.
Drive stud (6 each)
Blade spindles for Standard series cutting units have cast aluminum spindle
housings, sealed ball bearings, 25 mm (1 inch) spindle shafts, and are designed
to use 5.1 mm (0.20 inch) thick blades.
Disassembling the Blade Spindle
Refer to
for this procedure.
1. Remove the lock nut, disc spring washer, pulley, and bearing guard from
the top of the spindle shaft.
2. Remove the spindle shaft and bottom guard from the spindle housing.
3. Being careful not to damage the spindle housing bore, remove the bearings
and bearing spacer from the spindle housing. Discard the bearings.
4. Inspect the drive studs. Use an arbor press to replace any drive studs if
necessary.
Groundsmaster
®
3200, 3300 and 3310
Page 8–9
Cutting Units: Service and Repairs
19240SL Rev A
Summary of Contents for Groundmaster 31900
