Toro Groundmaster 31900, Service Manual, Page: 14 / 355

Jacking Instructions
DANGER
Mechanical or hydraulic jacks may fail to support the machine and
cause a serious injury.
• Use jack stands to support the raised machine.
• Use only mechanical or hydraulic jacks to lift the machine.
• Do not use the cutting unit or implement as a jacking point.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
FF
position and remove
the key from the key switch.
2. engage the parking brake and block the 2 rear wheels with chocks to prevent
the machine from moving.
3. Position the jack securely under the desired jack point:
• Front = Position the jack securely under the frame tube just behind the
front wheel.
• Rear = Position the jack securely under the frame directly in front of the
rear axle.
After raising the machine, use an appropriate jack stand under the machine
frame to support the machine.
g303670
Figure 1
1. Jack point – front 3. Jack point – rear
2. Jack stand point – front
4. Jack stand point – rear
IMPORTANT
Use two jack stands when supporting the machine.
Safety: Jacking Instructions Page 1–6 Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A