Toro GreensPro 1240, Service Manual

Page: 98 / 186

Removing the Hydraulic Pump (continued)
6. For assembly purposes, label all the hoses and fittings. Remove the hoses
from the fittings on the transmission assembly. Drain the hoses into a
suitable container.
7. Install clean caps and plugs on the disconnected hoses and fittings to prevent
hydraulic system contamination.
8. Disconnect the wire harness connector from the neutral switch.
9. Remove the traction cable clamp from the engine plate (below the frame
plate). Remove the traction cable from the pedal rod pivot, then loosen the
traction cable jam nuts and remove the traction cable from the frame bracket
(
Figure 38 ).
g271901
Figure 38
GreensPro 1260
1. Traction cable 3. Jam nut (2 each)
2. Pedal rod pivot assembly
10. Loosen the 2 set screws in the pump drive collar.
11. Remove the fasteners securing the hydraulic pump to the engine plate and
carefully remove the hydraulic pump from the hydraulic pump drive collar.
Locate and retrieve the square key.
12. Remove additional pump components as necessary.
13. If removing the hydraulic pump fittings is necessary, record the orientation of
the fittings for assembly purposes and discard the fitting O-rings.
Hydraulic System: Service and Repairs Page 5–52 GreensPro ™ 1240/1260
14211SL Rev A