Hydraulic Pump (GreensPro 1260)
g272542
Figure 37
1.
Hydraulic pump
5.
Plain washer (4 each)
2.
Pump drive collar
6.
Square key
3.
Set screw (2 each)
7.
Cap screw (2 each)
4.
Lock nut (2 each)
Removing the Hydraulic Pump
Refer to
for this procedure.
CAUTION
Before opening the hydraulic system, shut off the engine and press
the motion control pedals to release the pressure in the system and
avoid injury from the pressurized hydraulic fluid.
CAUTION
Use a suitable lifting device to safely raise and support the machine
to access the components under the chassis.
1. Park the machine on a clean, shut off the engine and engage the parking
brake.
2. Remove the transmission cover from the machine; refer to
.
3. Read and adhere to the
General Precautions for Removing and Installing the
Hydraulic System Components (page 5–35)
.
4. Clean the hydraulic hose ends and fittings being disconnected to prevent
hydraulic system contamination.
5. Drain the hydraulic fluid from the hydraulic tank into a suitable container.
GreensPro
™
1240/1260
Page 5–51
Hydraulic System: Service and Repairs
14211SL Rev A
Summary of Contents for GreensPro 1240
Page 4: ...Reader Comments Page 4 GreensPro 1240 1260 14211SL Rev A...
Page 8: ...Preface Page 8 GreensPro 1240 1260 14211SL Rev A...
Page 14: ...Safety Safety and Instructional Decals Page 1 6 GreensPro 1240 1260 14211SL Rev A...
Page 30: ...Specifications and Maintenance Special Tools Page 2 16 GreensPro 1240 1260 14211SL Rev A...
