Adjustments
Adjusting the Starter/Generator Drive Belt Tension (Model 04580)
For additional starter/generator service information; refer to
(Model 04580) (page 5–120)
.
1. Remove the fuel tank; refer to
Removing the Fuel Tank (page 4–4)
.
2. Tilt the operator seat forward and remove the starter/generator pulley cover.
3. Loosen the 4 cap screws (item 2) securing the starter/generator to the
engine frame and allow the extension spring to pull the starter/generator
counterclockwise to tension the drive belt.
g289346
Figure 29
1.
Generator pulley
4.
Extension spring
2.
Cap screw (4 each)
5.
Hex nut (2 each)
3.
Generator drive belt
6.
Adjustment pin
4. Measure the extension spring length. To apply the correct amount of belt
tension, the spring must be
108 to 110 mm (4.25 to 4.35 inch)
when
measured inside the spring hooks. Adjust the adjustment pin if necessary.
5. Tighten the 4 cap screws securing the starter/generator to the engine frame
in the sequence shown.
6. Install the starter/generator pulley cover.
7. Install the fuel tank; refer to
Installing the Fuel Tank (page 4–4)
.
Electrical System: Adjustments
Page 5–20
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
