InfoCenter
g288424
Figure 21
1.
Operator’s console
2.
InfoCenter
The InfoCenter Display is a three button LCD device located on the operator’s
console. The InfoCenter provides information to the machine operator during
machine operation, provides electrical system diagnostic assistance for
technicians, and allows access to adjustable machine and attachment settings.
Power for the InfoCenter is available when the key switch is in the ON or START
position. A 7.5 Amp fuse protects all of the key switched circuits, including the
InfoCenter power circuit.
The InfoCenter communicates with the other machine controllers on a Controller
Area Network (CAN) bus system; refer to
CAN bus Communications (page
5–12)
for additional information.
Note:
If the InfoCenter display (SC1) is replaced for any reason, the machine
software must be updated; contact an Authorized Toro Distributor for assistance.
Electrical System: Electrical System Operation
Page 5–10
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
