1
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar assembly
8
Hex-head bolt (3/8 x 1-1/2 inch)
8
Nut (3/8 inch)
Procedure
1.
Remove the top crate support from the crate.
2.
Remove the roll bar from the crate.
3.
Use 8 hex-head bolts (3/8 x 1-1/2 inch) and
8 nuts (3/8 inch) to secure the roll bar to the
roll-bar brackets on each side of the machine
(
).
Note:
Have an assistant help you to position
and secure the roll bar to the machine.
g277676
Figure 3
Left side of the machine shown
1.
Nut (3/8 inch)
3.
Hex-head bolt (3/8 x 1-1/2
inch)
2.
Roll bar
4.
Torque the fasteners to 51 to 65 N∙m (38 to 48
ft-lb).
2
Installing the Seat
Parts needed for this procedure:
1
Seat Kit (order separately; contact your authorized
Toro distributor)
Procedure
Acquire the Seat Kit (contact your authorized Toro
distributor) and refer to the kit
Installation Instructions
to install the seat.
3
Installing the Service Decal
Parts needed for this procedure:
1
Service decal (Part No. 137-8052)
Procedure
Install the service decal (Part No. 137-8052) to the
seat; refer to
for the premium seat (Model
No. 04729) or
for the standard seat (Model
No. 04508).
g277096
Figure 4
Premium Seat (Model No. 04729)
1.
Service decal
3.
18.5 cm (6.5 inches)
2.
2.5 cm (1 inch)
9
