Toro Greensmaster eFlex 2120 04046, Operator'S Manual

Page: 40 / 48

Controls System
Maintenance
Adjusting the Reel Control
If the reel control does not properly engage, an
adjustment is required.
1. Turn off the machine and disconnect the battery
pack.
2. Ensure that the reel control is disengaged.
3. At the transmission bulkhead, adjust the
reel-control cable (
Figure 51 ), to attain a spring
length of 70.6 to 72.4 mm (2.78 to 2.85 inches).
g017384
Figure 51
1. Reel-control cable 2. Jam nuts
4. At the control handle bulkhead, loosen the
reel-control cable until there is slack in the cable
(
Figure 52 ).
g017299
Figure 52
1. Reel control cable 2. Jam nuts
5. At the control handle bulkhead, tighten the
reel-control cable enough to remove the slack
from the cable without extending the spring.
6. Check the operation as follows:
•
Verify that the reel clutch teeth disengage
when the clutch is released and the reel
clutch teeth do not bottom out when
engaged.
Note:
Remove the rubber plug ( Figure 49 )
from the hole in the front of the transmission
to view reel clutch.
•
The reel stopping time must be less than 7
seconds with the reel to bedknife backed off.
•
Refer to the Service Manual or contact
your authorized Toro distributor for further
assistance.
40