2.
Press the wheel locking clip toward the center
of wheel and slide the wheel onto the hex shaft
(
).
g017591
Figure 19
1.
Locking clip
3.
Rotate the wheel back and forth until it fits onto
the axle and the locking clip is secured in the
groove on the axle shaft.
4.
Repeat the procedure on the opposite side of
the machine.
5.
Inflate the tires to 83 to 103 kPa (12 to 15 psi).
6.
Carefully lower the machine off of the kickstand
by pushing forward slowly or by lifting the lower
handle support, allowing the kickstand to spring
back to the S
TORAGE
position.
8
Installing the
Production-Year Decal
CE Machines Only
Parts needed for this procedure:
1
Production-year decal
Procedure
If you use this machine in a country that complies to
CE standards, apply the production-year decal near
the serial plate; refer to
g234770
Figure 20
1.
Serial plate
2.
Production-year decal
15
Summary of Contents for Greensmaster eFlex 2120 04046
Page 43: ...Notes...
Page 44: ...Notes...
