Height Adjuster Assembly
g251107
Figure 224
1.
Height adjuster knob
6.
Washer (2 each)
11.
Quick up lever
2.
Carriage bolt
7.
Compression spring
12.
Quick up cover
3.
Height-of-cut bracket
8.
Flange nut
13.
Detent spring
4.
Flange nut
9.
Height adjustment rod
14.
Button-head screw
5.
Groomer hose
10.
Groomer pin
15.
Height adjustment bolt
Note:
Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended (
).
Disassembling the Height Adjuster Assembly
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the 2 height adjustment bolts (item 15 in
) and 2 locknuts.
4. Remove the flange nut (item 4 in
) and carriage bolt that secure
the height adjuster assembly to the cutting unit side plate, and remove the
front roller and height adjuster from the cutting unit.
5. Disassemble the height adjuster assembly (
).
6. Clean all the components and inspect for wear or damage. Replace all the
components that are worn or damaged.
Assembling the Height Adjuster Assembly
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly
(
).
2. If both the height adjusters are removed, fit 1 height adjuster assembly to the
cutting unit side plate and secure it with the carriage bolt and flange nut. Do
Universal Groomer (Optional): Service and Repairs
Page 9–16
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
