Toro Greensmaster 3120, Operator'S Manual, Page: 28 / 48

Pre-Maintenance
Procedures
Removing the Seat
Assembly
Note:
If you remove the seat assembly frequently,
you can replace the roll pin with an R-key pin (Part
No. 3290-467).
Remove the seat assembly to access the valve block
area of the machine.
1. Unlatch and raise the seat, securing it with the
prop rod.
2. Disconnect the 2 wire-harness connectors under
the seat.
3. Lower the seat and remove the roll pin securing
the seat-pivot rod to the frame (
Figure 27 ).
g005497
Figure 27
1. Roll pin 2. Seat-pivot rod
4. Slide the seat-pivot rod to the left.
5. Move the seat forward and lift it out of the
machine.
6. Reverse the procedure to install the seat.
Raising the Machine
CAUTION
If the machine is not properly supported, it
could fall, crushing you or others.
Before servicing, support the machine with
jack stands or blocks of wood.
Before raising the machine, lower the cutting units.
The jacking points are as follows:
•
Right side—under the jack pad and adjacent to the
ROPS-support bracket (
Figure 28 )
•
Left side—under the step
•
Rear—at the caster fork
g005516
Figure 28
1. Jack pad
28