Toro Greensmaster 3120, Operator'S Manual, Page: 12 / 48

g005101
Figure 7
1. Lift arm 2. Lift hook
3. Slide the sleeve back on the ball joint receiver
and hook the receiver onto the cutting unit ball
stud. Release the sleeve so that it slides over
the stud and locks the assemblies together
(
Figure 8 ).
g020794
Figure 8
1. Pull frame 3. Ball stud
2. Pull arm
4. Mount the baskets on the pull frames, loosen
the jam nuts on the pull arms, and adjust the
ball sockets until there is 6 to 13 mm (1/4 to 1/2
inch) clearance between the lip of the basket
and the reel blades.
Note:
This prevents the basket from tipping the
cutting unit forward, causing the lift roller to come
off the lift arm while in the mowing operation.
Note:
Ensure that the basket lip is parallel with
the reel blades across the cutting unit. If the
basket is too close to the reel, it is possible for
the reel to contact the basket when the cutting
unit is raised off or lowered to the ground.
5. Align the sockets in the ball joints so that the
open side of the socket is centered toward the
ball stud, and tighten the jam nuts to secure the
sockets in position (
Figure 9 ).
g020795
Figure 9
1. Pull arm 3. Ball joint
2. Jam nut
6. Ensure that there is approximately 13 mm (1/2
inch) of threads exposed on each reel drive
motor mounting bolt (
Figure 10 ).
g005103
Figure 10
1. Drive motor 2. Mounting bolts
7. Coat the spline shaft of the motor with clean
grease.
8. Install the motor by rotating the motor clockwise
so that the motor flanges clear the studs, then
rotate the motor counterclockwise until the
flanges encircle the studs.
9. Tighten the mounting bolts ( Figure 10 ).
12