8
Installing the Groomer
Parts needed for this procedure:
4
Bolt (1/4 x 1-1/2 inches)
4
Locknut
4
Shaft clamp
1
Grooming reel (order separately; contact your
authorized Toro distributor)
Procedure
1.
Obtain a grooming reel appropriate for your
needs and cutting unit; contact your authorized
Toro distributor.
2.
Line up the grooming reel with the groomer drive
box and idler assembly (
).
g283516
Figure 17
1.
Drive-stub shaft
4.
Shaft clamp (4)
2.
Locknut (4)
5.
Bolt (4)
3.
Groomer assembly
3.
Secure the groomer to the machine as shown in
and snug the bolts.
4.
To prevent binding, set the height of cut and
height of groom, then loosen the bolts.
Note:
To set the height of cut, refer to your
cutting unit
Operator’s Manual
; refer to
the Groomer Height (page 11)
for adjusting the
height of groom.
5.
Torque the bolts to 5 to 7 N∙m (46 to 60 in-lb).
6.
Check and adjust the height of cut and height
of groom as necessary.
9
Summary of Contents for Greensmaster 1018
Page 17: ...Notes ...
