Toro Greensmaster 1018, Installation Instructions Manual

Page: 8 / 20

5. Insert and center the roller shaft between the
height-of-cut (HOC) brackets and secure it with
2 mounting screws (
Figure 14 or Figure 15 ).
You can install the mounting screws in the front
(as shown in
Figure 14 ) or rear side ( Figure 15 )
of the HOC brackets. Installing the screws in
the front side will allow the groomer to clear the
roller; installing them in the rear side will allow
the groomer to interlace with the roller.
g287988
Figure 14
Mounting screws installed to front side of HOC brackets
1. Roller 3. Height-of-cut bracket
(HOC) assembly
2. Mounting screw 4. Groomer guard
g287989
Figure 15
Mounting screws installed to rear side of HOC brackets
1. Groomer guard 3. Height-of-cut bracket
(HOC) assembly
2. Mounting screw 4. Roller
6. Attach the groomer guards to both sides of the
roller shaft (
Figure 14 ).
7. Torque the groomer guards to 22 to 24 N∙m (16
to 18 ft-lb).
Note:
For setups where additional spring force
is required, install the optional flange nut (Part
No. 3290-357) to the eye bolt to compress
the height-of-groom springs at a low height of
groom.
When using this optional part, set the spring
length to 19 mm (3/4 inch) when the groomer is
in the engaged position (
Figure 16 ).
g283296
Figure 16
1. Set the spring length to
19 mm (3/4 inch) in the
engaged position. 2. Optional flange nut (Part
No. 3290-357)
8