9
SET-UP INSTRUCTIONS
INSTALL HANDLE ASSEMBLY
1.
Insert key into keyway on handle mounting shaft
(Fig. 1).
Figure 1
1. Key
2. Handle mounting shaft
1
2
2.
Align keyway in handle assembly with key and
slide handle onto shaft (Fig. 2).
Figure 2
1. Handle assembly
2. Set screw
3. Roll pin
1
3
2
IMPORTANT:
Make sure wire harness hangs freely
and is not wrapped around handle.
3.
Insert roll pin into mounting hole and drive pin in
until flush with edge of handle assembly (Fig. 2).
4.
Apply loctite #242 to set screw. Install screw to
handle assembly and tighten (Fig. 2).
INSTALL REAR WHEELS
1.
Secure wheels to spindle hubs with lug nuts
(Fig. 3). Torque nuts to 65-90 ft-Ib.
1. Rear wheel
Figure 3
1
CHECK TIRE PRESSURE
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure. Correct
air pressure is 10 psi.
