g031538
Figure 69
1.
Cam
2.
Nut
7.
Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the
cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises
the handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position
(right or left); otherwise you may damage the
switch.
8.
Repeat steps
through
for the left
motion-control lever.
Hydraulic System
Maintenance
Hydraulic System Safety
•
Seek immediate medical attention if fluid is injected
into skin. Injected fluid must be surgically removed
within a few hours by a doctor.
•
Ensure that all hydraulic-fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
•
Keep your body and hands away from pinhole
leaks or nozzles that eject high-pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
Hydraulic System
Specifications
Hydraulic Fluid Type:
Toro
®
HYPR-OIL
™
500
hydraulic fluid
Hydraulic System Fluid Capacity:
4.7 L (159 fl oz)
Important:
Use the fluid specified. Other fluids
could damage the system.
Checking the Hydraulic
Fluid
Service Interval:
After the first 8 hours
Every 500 hours
Note:
Check the hydraulic-fluid level when the fluid
is cold.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the area around the cap and the filler neck
of the hydraulic tank (
46
Summary of Contents for GrandStand TURBO FORCE 74513
Page 58: ...Schematics g233853 Electrical Schematic Rev A 58...
Page 59: ...Notes...
