Toro GrandStand TURBO FORCE 74513, Operator'S Manual

Page: 44 / 60

g031344
Figure 65
Replacing the Transmission
Belt
Service Interval: Every 1,000 hours—Replace the
transmission belt.
1. Remove the fuel tank; refer to Removing the
Fuel Tank (page 35) .
2. Remove the hydraulic-reservoir cap.
3. Locate the drain plugs in the bottom of the
transmission and place a drain pan under the
plug (
Figure 66 ).
g032680
Figure 66
1. Drain plug
4. Allow the hydraulic fluid to drain from the
machine.
5. Remove the lower hydraulic hose ( Figure 67 ).
g031345
Figure 67
1. Lower hydraulic hose 3. Tension spring
2. Transmission belt
6. Remove the tension spring ( Figure 67 ).
CAUTION
The spring is under tension when
installed and can cause personal injury.
Wear safety glasses and be careful when
removing the spring.
7. Remove the deck belt from the clutch and clutch
stop (
Figure 67 ).
8. Install the new belt.
9. Install the tension spring and lower hydraulic
hose.
10. Install the drain plugs and torque to 22 to 27
N∙m (16 to 20 ft-lb).
11. Add hydraulic fluid to the fill level.
12. Install the hydraulic-reservoir cap.
44