Toro GrandStand 74574, Operator'S Manual

Page: 18 / 68

Operating the Ignition Switch
1. Turn the ignition key to the Start position ( Figure 14 ).
When the engines starts, release the key.
Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, allow a 15 second cool-down period between
attempts. Failure to follow these instructions can
burn out the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 14
2. Turn the ignition key to stop to turn off the engine.
Using the Fuel Shut-Off Valve
Close the fuel shut-off valve for transport, maintenance, and
storage (
Figure 15 ).
Ensure that the fuel shut-off valve is open when starting the
engine.
g026965
G008948
1
2
Figure 15
1. On position 2. Off position
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the right motion-control lever to neutral locked
position.
4. Set the parking brake; refer to Setting the Parking
Brake.
5. Move the blade-control switch (PTO) to the Off
position.
6. Move the throttle lever midway between the Slow and
Fast positions.
Note:
A warm or hot engine may not require choking.
18