Figure 70
1.
Cam
2.
Nut
8.
Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle, while moving it
counterclockwise (in the vertical position) raises the
handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position (right or
left), or you may cause damage to the switch.
Adjusting the Neutral Position for the
Motion-control Levers
Important:
Ensure the tracking of the mower is correct
after adjusting the motion-control levers. Adjusting the
tracking and aligning the motion-control levers front to
back is the same procedure (Figure 71).
Note:
Adjust the horizontal alignment before the front to
back alignment.
If the motion-control levers do not align front to back, or
the right side control lever does not move easily into the
neutral-lock position, adjustment is required.
1.
After the horizontal alignment is finished, check the
front to back alignment by slightly pushing the control
levers forward to take up any slack in the linkage for
the control levers (Figure 71).
G012706
1
2
3
4
Figure 71
1.
Left motion-control lever
3.
Neutral-locked position
2.
Right motion-control lever
4.
Align the control levers
front to back
2.
Ensure the right motion-control lever moves easily into
the neutral-lock position.
Note:
Turn the cable adjustment clockwise to
move the motion-control handle forward. Turn
the cable adjustment counterclockwise to move the
motion-control handle rearward.
3.
Rotate the cable adjustment on right side when
adjustment is needed.
Note:
Adjust the cable adjustment in quarter-turn
increments.
4.
After the right motion-control lever moves easily into
the neutral-lock position, adjust the left motion-control
lever to align with the right motion-control lever.
5.
Check for proper tracking; refer to Adjusting the
Tracking (page 40).
6.
Install the cable lock onto the cable-adjusting nuts to
secure the adjustment (Figure 72).
49
Summary of Contents for GrandStand 74568TE
