Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
LOW
to F
AST
position (
Power-Takeoff (PTO) switch
Use the power-takeoff (PTO) switch to start and stop
powered attachments (
).
Ignition Switch
Use this switch to start the engine. It has 3 positions:
S
TART
, R
UN
, and O
FF
.
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction.
Fuel-Shutoff Valve
Close the fuel-shutoff valve (located on the left side
of the fuel tank) when transporting or storing the
machine (
).
Accessory Frame
Use the accessory frame to attach only Toro-approved
accessories to the machine (
). Refer to the
Operator’s Manual
for the accessory for installation
instructions.
Accessory-Frame Lock
The accessory-frame lock holds the frame in place on
the machine using the lock pin. Always lock the frame
unless a hydraulic kit is installed with an accessory
on the machine (
).
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated (
The MIL is the red light located in the console panel.
When the MIL illuminates, make initial troubleshooting
checks.
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Adjustable Casters
When using the machine
with
an attachment, refer
to the
Operator’s Manual
for that attachment for the
correct caster position (
). Do not operate the
machine without an attachment installed on the front
of the machine.
g033081
Figure 6
Right Caster Shown
1.
Caster bolt and nut in front
caster hole
2.
Caster holes
Specifications
Note:
Specifications and design are subject to
change without notice.
Width
122 cm (48 inches)
Length with platform down
191 cm (75 inches)
Length with platform up
155 cm (61 inches)
Height
122 cm (48 inches)
Weight
308 kg (680 lb)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
10
