Toro GrandStand 72504TE, Operator'S Manual

Page: 9 / 60

g216020
Figure 5
1. Safety-interlock symbols 3. Hour meter
2. Battery light
Safety-Interlock Indicators
Symbols on the hour meter indicate with a black
triangle that the interlock component is in the correct
position (
Figure 5 ).
Battery-Indicator Light
If you turn the key to the O
N
position for a few
seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when you turn the key to the
O
N
position and when the charge is below the correct
operating level ( Figure 5 ).
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
LOW
to F
AST
position ( Figure 4 ).
Choke Control
Use the choke control to start a cold engine. Pull the
choke control up to engage it. Push down on the
choke control to disengage it.
Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O
FF
, R
UN
, and S
TART
. Refer to
Operating the Ignition Switch (page 16) .
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction (
Figure 4 ).
Fuel-Shutoff Valve
Close the fuel-shutoff valve when transporting or
storing the machine; refer to
Using the Fuel-Shutoff
Valve (page 22) .
Specifications
Note:
Specifications and design are subject to
change without notice.
Cutting width 122 cm (48 inches)
Width—side-discharge
machines with deflector down 163 cm (64 inches)
Width—side-discharge
machines with deflector raised 127 cm (50 inches)
Length with platform down 191 cm (75 inches)
Length with platform up 155 cm (61 inches)
Height 122 cm (48 inches)
Weight 401 kg (884 lb)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
9