Toro Flex-Force Power System 60V MAX 21in Recycler 21323, Operator'S Manual

Page: 17 / 24

Folding the Handle
WARNING
Unfolding the handle improperly can damage the cables, causing an unsafe operating
condition.
• Do not damage the cable(s) when folding or unfolding the handle.
• Ensure that the cable(s) are routed to the outside of the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1. Remove the electric-start button ( Figure 13 ).
g296946
Figure 13
2. Remove the battery from the machine.
3. Hold the handle while disengaging the handle
locks to avoid pinching your hands.
4. Disengage the handle locks until you can move
the upper handle freely.
5. Fold the handle forward to the fully forward
position as shown in
Figure 15 .
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
6. To unfold the handle, refer to 2 Unfolding the
Handle (page 9) .
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Adjusting the Cutting
Height (page 13) .
3. Disengage the handle locks ( Figure 14 ).
g409527
Figure 14
4. Fold the handle fully forward; refer to Folding
the Handle (page 17) .
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space (
Figure 15 ).
g409512
Figure 15
17